44
En
You can connect a Yamaha Bluetooth wireless audio receiver (such as YBA-10, sold separately) to the DOCK terminal of
this unit and enjoy the music contents stored in your Bluetooth component (such as a portable music player) without
wiring between this unit and the Bluetooth component. You need to perform “Pairing” the connected Bluetooth wireless
audio receiver and your Bluetooth component in advance.
Note
•
This unit supports A2DP (Advanced Audio Distribution Profile) of the Bluetooth profile.
“Pairing” refers to the operation of registering a Bluetooth
component for Bluetooth communications. Pairing must
be performed when using a Bluetooth component with the
Bluetooth wireless audio receiver connected to this unit
for the first time or if the pairing data has been deleted.
y
•
You only need the pairing operation for the first time that you use the
Bluetooth component with the Bluetooth wireless audio receiver.
•
Pairing requires operations on this unit and on the other component with
which Bluetooth communications are to be established. If necessary,
refer to the other component’s operating instructions.
■
Pairing the Bluetooth™ wireless audio
receiver and your Bluetooth™ component
1
Rotate the
R
INPUT
selector (or press
d
DOCK
) to select “BLUETOOTH” (DOCK)
as the input source.
2
Turn on the Bluetooth component you want
to pair with and set it to pairing mode.
For details on operation of the Bluetooth component,
refer to the manual supplied with it.
3
Press
r
OPTION
on the remote control.
The Option menu for “BLUETOOTH” is displayed
(page 47).
4
Press
j
Cursor
n
to select “Pairing” and
then press
j
ENTER
.
“Searching” appears and the pairing operation starts.
y
•
To cancel pairing, press
j
RETURN
.
•
You can also start pairing operation by holding down
E
MEMORY
on the front panel.
5
Make sure the Bluetooth component
recognizes the Bluetooth wireless audio
receiver.
If the Bluetooth component detects the Bluetooth
wireless audio receiver, “YBA-10 YAMAHA”
(example) appears in the Bluetooth device list.
6
Select the Bluetooth wireless audio receiver
in the Bluetooth device list, and enter a pass
key “0000” into the Bluetooth component.
When pairing is complete, “Completed” appears on
the front panel display.
y
•
The Yamaha Bluetooth wireless audio receiver can be paired with up to
eight Bluetooth components. When pairing is conducted successfully
with a ninth component and the pairing data is registered, the pairing data
for the least recently used other component is cleared.
1
Rotate the
R
INPUT
selector (or press
d
DOCK
) to select “BLUETOOTH” (DOCK)
as the input source.
2
Press
r
OPTION
on the remote control.
3
Press
j
Cursor
n
to select “Connect” and
then press
j
ENTER
.
After you execute “Connect”, communication with
the Bluetooth component is established. When the
connected Bluetooth wireless audio receiver
recognizes the Bluetooth component, “BT
Connected” appears on the front panel display.
y
•
When you press
j
ENTER
on the remote control, the connected
Bluetooth wireless audio receiver searches and connects to the last
connected Bluetooth component. If the Bluetooth wireless audio
receiver cannot find the Bluetooth component, “Not found”
appears on the front panel display.
•
To disconnect the Bluetooth wireless audio receiver from the
Bluetooth component, display the Option menu again, select
“Disconnect” and then press
j
ENTER
.
4
Start playback of the Bluetooth component.
Using Bluetooth™ components
Pairing the Bluetooth™ wireless audio
receiver and your Bluetooth
component
To ensure security, a time limit of 8 minutes is set for
the pairing operation. You are recommended to read
and fully understand all the instructions before starting.
Input
DSP
Volume Trim
Connect
Pairing
Option Menu
BLUETOOTH
7ch Enhancer
Playback of the Bluetooth™
component
