En
93
Sound
Configures the audio output settings.
■
Lipsync
Adjusts the delay between video and audio output.
❑
Auto
Adjusts the delay between video and audio output automatically when a TV that
supports an automatic lipsync function is connected to this unit via HDMI. If necessary,
you can fine-adjust the audio output timing. “Offset” shows the difference between
automatic adjustment and fine adjustment.
Setting range
0ms ~ 250ms (1ms steps)
Default
0ms
❑
Manual
Adjusts the delay between video and audio output manually.
Setting range
0ms ~ 250ms (1ms steps)
Default
0ms
■
Dynamic Range
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and
DTS signals) playback.
Settings
■
Max Volume
Sets the maximum volume so that sound is not too loud.
Setting range
-30.0dB ~ +15.0dB (5.0dB steps), +16.5dB
Default
+16.5dB
■
Initial Volume
Sets the initial volume for when this receiver is turned on.
Settings
■
Adaptive DSP Level
Selects whether to automatically adjust the CINEMA DSP effect level in conjunction with
volume adjustments.
Settings
Maximum (default)
Produces audio without adjusting the dynamic range.
Standard
Optimizes the dynamic range for regular home use.
Minimum/Auto
Sets the dynamic range to make clear sound even at night or at low
volumes.
When playing back Dolby TrueHD signals, the dynamic range is
automatically adjusted based on the input signal information.
Off (default)
Sets at the level when this unit last entered standby mode.
On
Sets at Mute, or -80.0dB ~ +16.5dB (0.5dB steps). (This setting works
only when “Max Volume” is set higher.)
Off
Does not adjust the effect level automatically.
On (default)
Adjusts the effect level automatically.
