Yamaha RX-A3060, Owner'S Manual

Page: 39 / 230

En
39
⬛
Connecting front speakers that support bi-amp
connections
When using front speakers that support bi-amp connections, connect them to the FRONT
terminals and EXTRA SP 1 terminals.
To enable the bi-amp function, configure the “Power Amp Assign” setting in the “Setup” menu
after connecting the power cable to an AC wall outlet (p.52).
X
The FRONT terminals and EXTRA SP 1 terminals output the same signals.
⬛
Connecting Zone2/3 speakers
When using Zone2/3 speakers, connect them to the EXTRA SP 1-2 terminals.
To utilize the EXTRA SP 1-2 terminals for Zone2/3 speakers, configure the “Power Amp Assign”
setting in the “Setup” menu after connecting the power cable to an AC wall outlet (p.52).
X
• You can select a zone (Zone2 or Zone3) to be assigned to the EXTRA SP 1-2 jacks in “Power Amp Assign” (p.131)
in the “Setup” menu.
• You can also connect Zone2 and Zone3 speakers using an external amplifier (p.105).
Caution
Before making bi-amp connections, remove any brackets or cables that connect a woofer with a
tweeter. Refer to the instruction manual of the speakers for details. If you are not making bi-amp
connections, make sure that the brackets or cables are connected before connecting the speaker
cables.
SPEAKERS
CENTER FRONT SURROUND BACK R.PRESENCE
R R R L L L
F. PRESENCE
ZONE 2/ZONE 3/BI-AMP ZONE 2/ZONE 3/F.PRESENCE
EXTRA SP1
R L
SINGLE
EXTRA SP2
1 2
3
9
4 5
9
The unit (rear)
SPEAKERS
CENTER FRONT SURROUND BACK SURROUND R.PRESENCE
R L R R R L L L
F. PRESENCE
ZONE 2/ZONE 3/BI-AMP ZONE 2/ZONE 3/F.PRESENCE
EXTRA SP1
R L
SINGLE
EXTRA SP2
1
4
6
2
5
7
3
1 2
1 2
The unit (rear)
Main zone
Zone2 or Zone3
Zone2 or Zone3