Periodic maintenance and adjustment
59
14. Install the drive guard, and then install the
left side cover and the shroud.
ESU12104
Drive chain housing
To check the drive chain housing oil level
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Remove the shroud and the right side
cover. (See page 42 for removal proce-
dures.)
3.
Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
4.
Remove the dipstick and check that the
oil is between the maximum and mini-
mum level marks on the “REVERSE”
side of the dipstick. If the oil is below the
minimum level mark, add sufficient oil of
the recommended type to raise it to the
maximum level mark.
NOTICE:
Make
sure that no foreign material enters
the drive chain housing.
[ECS00531]
5.
Install the dipstick, making sure to align
the notch in the dipstick handle with the
projection on the drive chain housing.
1. Left lower cover
1. Dipstick
1
1
1. Maximum level mark
2. Minimum level mark
Recommended drive chain oil:
SAE 75W or 80W API GL-3 Gear oil
U8JA10E0.book Page 59 Tuesday, May 19, 2009 2:37 PM
