Yamaha ROADLINER XV19SW, Service Manual

Page: 103 / 444

ENGINE
3-13
CAUTION:
EC1D71008
When starting the engine make sure the dip-
stick is securely fitted into the oil tank.
12.Fill: (when engine is disassembled)
• Crankcase and oil tank
(with the specified amount of the recom-
mended engine oil)
13.Install:
• Engine oil filler cap
14.Start the engine, warm it up for several min-
utes, and then turn it off.
15.Check:
• Engine
(for engine oil leaks)
16.Check:
• Engine oil level
Refer to “CHECKING THE ENGINE OIL
LEVEL” on page 3-11.
17.Check:
• Engine oil pressure
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Slightly loosen the oil gallery bolts “1”.
b. Start the engine and keep it idling until engine
oil starts to seep from the oil gallery bolts. If
no engine oil comes out after one minute, turn
the engine off so that it will not seize.
c. Check the engine oil passages, the oil filter
cartridge and the oil pump for damage or
leakage. Refer to “OIL PUMP” on page 5-95.
d. Start the engine after solving the problem(s)
and check the engine oil pressure again.
e. Tighten the oil gallery bolts to specification.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
EAS20840
CHECKING THE TRANSFER GEAR OIL
LEVEL
1. Stand the vehicle on a level surface.
NOTE:
• Place the vehicle on a suitable stand.
• Make sure the vehicle is upright.
2. Remove:
• Transfer gear oil check bolt “1”
3. Check:
• Transfer gear oil level
The transfer gear oil level should be up to the
brim “1” of the hole.
Below the brim
→
Add the recommended
transfer gear oil to the proper level.
CAUTION:
EC1D71024
Do not allow foreign materials to enter the
transfer gear case.
4. Install:
• Transfer gear oil check bolt
Engine oil quantity
Total amount
5.20 L (5.50 US qt) (4.58 Imp.qt)
Engine
3.2 L (3.38 US qt) (2.82 Imp.qt)
Oil tank
2.0 L (2.11 US qt) (1.76 Imp.qt)
1
T
R
.
Oil gallery bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
Type
SAE80 API GL-4 Hypoid gear oil
1
1