Yamaha RCX series, User Manual

Page: 32 / 84

2-10
Chapter
2
CONNECTION
6.1 Parameter setting for CC-Link serial I/O board
[Operation]
1. Press the
F 1
(PARAM) key in "SYSTEM" mode to enter "SYSTEM>PARAM" mode.
2. Press the
F 5
(OP. BRD) key in "SYSTEM>PARAM" mode to enter the option board
parameter setting mode.
The option boards installed in the controller are displayed in order on the MPB
screen.
ＳＹＳＴＥＭ ＞ＰＡＲＡＭ＞ＯＰ．ＢＲＤ Ｖ８．１８
１．ＤＩＯ＿Ｎ（１） ＶＡＬＩＤ
２.． −−−
３．ＣＣＬｎｋ（Ｓ１／１０Ｍ） ＶＡＬＩＤ
４． −−−
ＳＥＬＥＣＴ
Option boards installed into the option slots are displayed on the MPB screen.
Type Display Meaning
Option DIO
DIO_N(n)
An option DIO board of NPN specifications is installed. The
number in parentheses is an ID number.
DIO_P(n)
An option DIO board of PNP specifications is installed. The
number in parentheses is an ID number.
Serial I/O
CCLnk(n/m)
A CC-Link unit is installed. Letters in parentheses indicate a
station number "n" and a communication speed "m".
D_Net(n/m)
A DeviceNet unit is installed. Letters in parentheses indicate a
MAC ID number "n" and communication speed "m".
Profi(n/m)
A Profibus unit is installed. Letters in parentheses indicate a
station address "n" and communication speed "m".
Network E_Net An Ethernet unit is installed.
YC-Link YCLnk(Mn)
A YC-Link unit is installed. Letters in parentheses indicate a
station number "n".
3. In "SYSTEM>PARAM>OP. BRD" mode, select the "CCLnk" with the cursor (
↑
/
↓
) keys
and press the
F 1
(SELECT) key.
ＳＹＳＴＥＭ ＞ＰＡＲＡＭ＞ＯＰ．ＢＲＤ＞ＳＥＬＥＣＴ Ｖ８．１８
１．ｂｏａｒｄ ｃｏｎｄｉｔｉｏｎ ＶＡＬＩＤ
２．ｒｅｍｏｔｅ ｃｍｄ ／ ＩＯ ｃｍｄ（ＳＩ０５） ＶＡＬＩＤ
３．Ｏｕｔｐｕｔ ＭＳＧ ｔｏ ＳＯＷ（１） ＩＮＶＡＬＩＤ
ＥＤＩＴ ＪＵＭＰ
6. Parameter setting for CC-Link serial I/O board