Yamaha R1 Series 2015, Service Manual

Page: 46 / 704

FEATURES
1-37
3. Select STREET MODE or TRACK MODE (or
select the triangle mark to exit).
4. Long push the wheel switch to exit the MENU
screen or use the wheel switch to select an-
other module.
“YRC Setting”
This module allows you to customize the four
YRC modes MODE-A, MODE-B, MODE-C,
MODE-D by adjusting the setting levels (or
on/off status as applicable) of YRC items PWR,
TCS, SCS, LCS, QSS, and LIF. For YZF-R1M,
you can select the ERS mode to be associated
with each YRC mode, and also adjust the setting
levels of the ERS modes.
TIP
•
TCS has 9 setting levels and ERS has 6
modes.
•
Whenever there are more selections (setting
levels or modes) available than can be shown
on the screen at one time, a scroll bar will ap-
pear to notify you that additional selections are
available by scrolling.
PWR
Select PWR-1 for the most aggressive throttle
response, PWR-2 and PWR-3 for smoother
throttle grip/engine response, and use PWR-4
for rainy days or whenever less engine power is
desirable.
TCS
This model uses a variable traction control sys-
tem. For each setting level, the further the vehi-
cle is leaned over, the greater the amount of
traction control (system intervention) is applied.
There are 9 setting levels available. Setting level
1 applies the least amount of overall system in-
tervention, while setting level 9 applies the great-
est amount of overall traction control.
TIP
• TCS can only be turned on or off via the main
screen using the mode switch.
• When TCS has been turned off, TCS, SCS,
LCS, and LIF will be set to OFF and cannot be
adjusted. When TCS is turned on again, these
related-traction control functions will return to
their previous setting levels.
SCS
SCS can be set to OFF, 1, 2, and 3. OFF turns
the slide control system off, setting level 1 pro-
vides the least amount of system intervention,
and setting level 3 provides the greatest amount
1. PWR-1
2. PWR-2
3. PWR-3
4. PWR-4
5. Throttle valve opening
6. Throttle grip operation
1. System intervention
2. Lean angle
5
6
4
3
2
1
1
5
4
3
2
6
9
87
1
TCS
2