44
En
Optimizing the speaker settings automatically (YPAO)
Error messages
If any error message is displayed during the measurement, resolve the problem and perform YPAO again.
Note
After checking the error message, press the cursor key (
D
) to return to the previous state and follow the procedure below,
– To start the measurement again:
Use the cursor keys (
B
/
C
) to select “Retry” and press ENTER. Proceed to Step 5 in page 43.
– To exit YPAO:
Use the cursor keys (
B
/
C
) to select “Exit” and press ENTER.
Error message
Cause
Remedy
E-1 Noisy
The noise is too loud.
Keep the room quiet and start the measurement
again.
E-2 No Signal
The YPAO microphone cannot detect test tones.
Connect the YPAO microphone to the YPAO
MIC jack firmly and start the measurement
again. If this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or service
center.
E-3 No MIC
The YPAO microphone has been removed.
Connect the YPAO microphone to the YPAO
MIC jack firmly and start the measurement
again.
E-4 User Cancel
The measurement has been canceled.
Start the measurement again as necessary.
E-5 PHONES
The headphones are connected to the PHONES
jack of this unit.
Disconnect the headphones and start the
measurement again.
E-10 Internal Error
An internal error has occurred.
Exit YPAO and then turn off and on this unit. If
this error occurs repeatedly, contact the nearest
authorized Yamaha dealer or service center.
E-20 No SPEAKERS
Speakers are not detected.
Press SPEAKERS A/B to select the speakers to
be used and start the measurement again.
If this error occurs even when the speakers are
properly selected, turn off this unit and check
the speaker connections.
E-21 Control Knob
The BASS/TREBLE/BALANCE/LOUDNESS
control positions are improper.
Set all the controls to the center position and
start the measurement again.
E-22 Pure Direct
Pure Direct is turned on.
Press PURE DIRECT on the front panel to turn
off Pure Direct and start the measurement again.
Noisy
YPAO E-1
