5
En
glish
1-3
Connecting Speakers
Connect the speakers as illustrated. Connect a subwoofer if needed.
1
Peel back about 10 mm of insulation from the
end of the speaker cable and twist the core
wires tightly.
2
Turn the knob of the speaker jack to the left to
loosen it, and insert the core wires of the
speaker cable into the hole of the jack.
3
Turn the knob back to the right to tighten it.
NOTE
• Use speakers with an impedance of 4-ohms or higher.
• If using 4-ohm speakers (or higher than 4-ohm but lower than
8-ohm), change the impedance settings of this product. These
settings can be changed in the product’s Advanced Setup menu.
See the User Guide for details.
ANALOG IN
COAXIAL
OPTICAL
USB
SERVICE
NETWORK
TV [ARC]
DIGITAL IN
ANTENNA
SPEAKERS
CD
LINE
L
R
L
R
12V
0.1A
TRIGGER
OUT
SUBWOOFER
OUT
FM
AM
75
PHONO
L
R
PRE OUT
L
L
R
GND
1
2
R
A
B
2
1
+
– –
+
Speaker
(Right channel)
Subwoofer (built-in amp)
Speaker
(Left channel)
10 mm
NOTICE
NOTICE is used with information for preventing
product failure, damage or malfunction.
• Do not allow the core wires of a speaker cable to touch the
core wires of another speaker cable or any metal parts of the
product. Doing so may damage the product and/or the
speakers.
