Yamaha R-3, Owner'S Manual

Page: 38 / 98

Instrument an d control functions
4-19
4 TIP
For ABS models, be sure to install the
drive chain guard by installing the col-
lars and bolts, and then tighten the
bolts to the specified torque.
EAU84680
Lu gg a g e strap hol d ers
Use the indicated strap points to se-
cure luggage ties to the vehicle.
EAU15306
Si d estan d
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
EWA10242
The vehicle must not b e ri dd en with
the si d estan d d own, or if the si d e-
stan d cannot b e properly move d up
(or d oes not stay up), otherwise the
si d estan d coul d contact the g roun d
an d d istract the operator, resultin g
in a possi b le loss of control.
Yamaha’s i g nition circuit cut-off
system has b een d esi g ne d to assist
the operator in fulfillin g the respon-
si b ility of raisin g the si d estan d b e-
fore startin g off. Therefore, check
Sprin g preloa d settin g :
Minimum (soft):
1
Standard:
4
Maximum (hard):
7
Ti g htenin g torque:
Drive chain guard bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
1. Luggage strap holder
1
UB7PEZE0.book Page 19 Thursday, May 9, 2019 9:34 AM