163
T h e P a t t e r n J o b s
,
11
02 : Modify Velocity
Increases or decreases the velocity values of all notes in the speci-
fied track and range of measures.
The “
TR
” parameter selects the track to be affected by the Modify
Velocity job: D1, D2, PC, BA, C1, C2, C3, C4.
The “
M
” parameters above the graphic bar are used to specify the
first measure:beat and last measure:beat of the range to be modified.
The “
SetAll
” parameter makes it possible to set all notes in the
specified range to a single velocity value from “1” to “127”. “Set All” can
also be turned “Off” when the “Rate” and “Offset” parameters, below,
are to be used for velocity modification.
The “
Rate
” parameter allows you to change the Velocity value of
each note without affecting the velocity ratios between notes (proportional
change). A setting of
“100%” maintains the
absolute velocity differ-
ences between notes,
while lower (higher) values
will decrease (increase)
the velocity values to the
corresponding percentage,
resulting in a narrower
(wider) dynamic range.
The range is from “0%” to
“200%”.
96
64
32
127
96
48
32
16
63
48
127
96
48
127
127
Original
velocities
Rate = 50%
Rate = 150%
First beat.
First measure.
Last measure.
Last beat.
