Periodic maintenance and adjustment
80
NOTICE
ECS00560
Avoid scratching the skis when loading
and unloading the snowmobile, when
riding in areas with little or no snow, or on
sharp edges such as concrete, curbs, etc.
This will wear or damage the skis.
To align the skis
1.
Turn the handlebar so the skis face
straight ahead.
2.
Check the following for ski alignment:
●
Skis are facing forward.
●
Ski toe-out (distance A – distance B) is
within specification.
TIP
Move the front tip of each ski fully inward be-
fore measuring or aligning.
3.
If the alignment is not correct, consult a
Yamaha dealer.
ESU12152
Steering system
Check the handlebar for excessive free play.
To check the handlebar
1.
Push the handlebar up and down and
back and forth.
2.
Turn the handlebar slightly to the right
and left.
If excessive free play is felt, consult a Yamaha
dealer.
ESU12176
Drive track and slide runners
Drive track
WARNING
EWS00481
A broken track, track fittings or debris
thrown by the drive track could be danger-
ous to an operator or bystanders. Observe
the following precautions:
●
Do not allow anyone to stand behind the
snowmobile when the engine is running.
●
When the rear of the snowmobile is
raised to allow the drive track to spin, a
suitable stand must be used to support
the rear of the snowmobile. Never allow
anyone to hold the rear of the snowmo-
Ski runner wear limit:
6.0 mm (0.24 in)
Ski wear limit:
PZ50GT 13.0 mm (0.51 in)
PZ50MP 24.0 mm (0.94 in)
PZ50MT 24.0 mm (0.94 in)
PZ50RT 13.0 mm (0.51 in)
PZ50VT 13.0 mm (0.51 in) (CAN)
PZ50VT 24.0 mm (0.94 in)
(FIN)(SWE)
1. Distance A
2. Distance B
Ski toe-out (distance A – distance B):
0.0–15.0 mm (0.00–0.59 in)
U8GKS6E0.book Page 80 Tuesday, April 17, 2012 8:48 AM
