PSR-SX600 Reference Manual
17
1
V
oices
Effect Page
1 Reverb Depth/Chorus Depth/DSP Depth/Panel Sustain
2 DSP Type
3 EQ
Harmony/Arp Page
Same as the display called up via [MENU]
→
TAB [
E
] Menu1
→
Cursor buttons [
][
][
E
][
F
]
Harmony/Arpeggio
→
[ENTER], with the exception of the following points:
• The parameters set via the [7
] (Detail) buttons are shown on the top of the display.
• The [8
] (Compare) and [8
] (Save) buttons are available (see steps 4–5 on
[1
]/
[2
]
Reverb Depth
Adjusts the reverb depth.
[3
]/
[4
]
Chorus Depth
Adjusts the chorus depth.
[5
]
DSP On/Off
Determines whether the DSP effect is on or off.
This setting can also be made from the VOICE EFFECT [DSP] button on the
panel.
[6
]
DSP Depth
Adjusts the DSP depth.
If you want to re-select the DSP type, you can do so in the “2 DSP Type” menu
explained below.
[7
]
Panel Sustain
Determines the sustain level applied to the edited Voice when the sustain effect is
on. To turn on/off the sustain effect, press the [SUSTAIN] button, or set it from
the display below.
[MENU]
→
TAB [
E
] Menu1
→
Cursor buttons [
][
][
E
][
F
] Voice Setting
→
[ENTER]
→
TAB [
E
] Voice Control
[2
]/
[3
]
Category
Selects the DSP effect category and type. Select a type after selecting a category.
[4
]/
[5
]
Type
[6
]/
Detail
Calls up a detailed setting display. Use the [2
]–[4
] buttons to select the
desired parameter, and then use the [5
]–[6
] buttons to adjust the value
of the desired parameter. To close the detailed setting display, press the [EXIT]
button.
[1
]/
[2
]
Low Frequency
Determines the desired frequency of the low frequency band to be controlled, over
a range of 32Hz–2.0kHz.
[3
]
Low Gain
Boosts or attenuates the low EQ band set above over a range of -12dB–12dB.
[4
]/
[5
]
High Frequency
Determines the desired frequency of the high frequency band to be controlled,
over a range of 500Hz–16kHz.
[6
]
High Gain
Boosts or attenuates the high EQ band set above over a range of -12dB–12dB.
