Appendix
65
En
English
Appendix
• Place the DRX-730 on a stable surface close to
your TV and the other AV components that you
intend to use with it.
• Do not place anything on top of the DRX-730.
• Do not place the DRX-730 on top of your TV.
And keep it away from components that are
sensitive to magnetism, such as video recorders.
• Do not place the DRX-730 on top of a power
amplifier or any other heat producing
component. If you install the DRX-730 in a rack,
place the amp or other heat producing
component on the bottom shelf to keep it as far
away as possible from the DRX-730.
Avoid locations that are...
• Subject to direct sunlight
• Very humid or poorly ventilated
• Subject to extreme temperatures
• Subject to vibration
• Very dusty
• Subject to smoke, steam, or hot temperatures,
such as a kitchen
Before you move the DRX-730, eject the disc if
loaded, close the disc tray, and press STANDBY/ON
to set it to standby. When the “STANDBY” message
has disappeared, disconnect the power cable from the
AC wall outlet.
Note:
• Disconnecting the power cable before the
“STANDBY” message has disappeared may reset
the DRX-730 to its factory defaults.
• Moving the DRX-730 with a disc inside may cause
damage.
You can reset the DRX-730 to its factory defaults.
1
Set the DRX-730 to standby.
2
While holding down Stop ( ) on the
DRX-730’s front panel, press STANDBY/ON,
keeping Stop ( ) pressed until “DVD — NO
REQ.” appears on the display.
3
Press Play/Pause (
/ ) repeatedly to select
“DVD—INIT.”
If you change your mind at this point, select
“DVD — NO REQ.” instead.
4
Press STANDBY/ON.
The DRX-730 is reset to its factory defaults and
goes on standby. Press STANDBY/ON again to
turn the DRX-730 back on.
The TV Screen, HDMI Resolution, and other
settings will be set to their factory defaults. The
HDMI Audio setting will be set to off.
Looking after the DRX-730
Installation
Moving the DRX-730
Resetting the DRX-730
STANDBY/ON
USB
PORTABLE
PHONES
INPUT
VOLUME
TIMER
HDMI
PROGRESSIVE
Stop ( )
Play/Pause (
)
STANDBY/ON
Summary of Contents for PianoCraft DRX-730
Page 626: ...Printed in Malaysia WQ26630 1 IP ...