Yamaha O2R, Owner'S Manual

Page: 270 / 414

160 MIDI
02R User’s Guide
Program Change Assign
MIDI Program Change messages are used to recall scene memories.
Shown below is the MIDI 2/5 page—MIDI Program Change Assign.
The default Program Change Assign table consists of a mapping of
Program Change numbers 1 through 96 to Scene Memories 1 through 96.
Program Change numbers 98 through 127 are mapped to nothing.
Messages containing those Program Change numbers are ignored.
Program Change number 97 is mapped to Scene Memory 0 (initial data). A
scene memory to Program Change assignment table is provided on page
255.
TABLE RESET
The TABLE RESET command sets the Program Change Assign table back
to its default mapping.
UNDO
The UNDO command restores the Program Change Assign table to its
previous state.
Backup
You can create a Program Change Assign table and save it to a data storage
device such as a MIDI data filer by executing the Program Change Assign
table Bulk Dump command.
1. Use the [MIDI] button to
locate the MIDI 2/5
page.
2. Select a Program
Change number with
the CURSOR buttons. Use
the encoder wheel to
change the value of the
corresponding Scene
Memory number.
Press the [ENTER] button
to enable or disable the
current Scene Memory
number. When a
memory is disabled,
“---” appears beside the
Program Change
number.
3. Use the CURSOR buttons
to select the “TABLE
RESET” control icon and
press the [ENTER] button.
4. Select the “UNDO”
control icon using the
CURSOR buttons and
press the [ENTER] button.
MIDI