Yamaha O2R, Owner'S Manual

Page: 161 / 414

MIXING Display Functions 51
02R User’s Guide
EQ
The 02R is equipped with a four-band, fully parametric EQ, with variable
bandwidth, center frequency, gain, and ON/OFF parameters.
EQ can be applied to the input channels (MIC/LINE 1 through 16, LINE
17/18 through 23/24), the tape and effect return channels (TAPE 1 through
16, EFF1 and EFF2), and the stereo output. For stereo channels, the
equalization curve is applied equally to both channels.
Shown below is the EQ 1/2 page.
Similar to the VIEW display function, the EQ display function shows the
equalization for the currently selected channel only.
The top of the display shows the EQ library icon, the equalization curve,
and a level meter for the currently selected channel pair. The vertical dotted
line in the equalization curve indicates the center frequency of the selected
band.
The bottom of the display contains the icons for adjusting the parameters
for the currently selected channel:
• ATT —The attenuator rotary icon is used to attenuate the channel level.
Operation for input channels 17 to 24, and MIC or TAPE channels
configured as stereo pairs is as follows: since only one attenuation
control is displayed on the EQ page, the attenuation functions of each
channel are linked to preserve their relative settings. If the channel
whose control cannot be seen reaches the minimum or maximum
attenuation setting, a message appears. The indicators in the PAN
[L/ODD] and [R/EVEN] buttons indicate whether the left or right
channel of a pair is selected.
1. Use the (EQ) button to
select the EQ 1/2 page.
2. Select a channel using
the [SEL] buttons.
3. Use the CURSOR buttons
to select the EQ ON
icon. Press the [ENTER]
button to turn the EQ on
or off.
The icon changes from
ON to OFF. When the EQ
is on, the icon is
highlighted.
4. Select a icon using the
CURSOR buttons, for
example the “F” control
for the H-MID band.
5. To change the value of
the selected item,
rotate the encoder
wheel until the desired
value is shown.
EQ