Yamaha O2R, Owner'S Manual

Page: 144 / 414

34 MIXING Display Functions
02R User’s Guide
Delay
The DELAY display function is used to apply a small amount of delay to
input or return signals to compensate for situations such as line or cabling
delays or the gap between the record and playback heads (or circuitry) of
your multitrack recorder. You can delay a signal from 0 to 2,600
samples—at 44.1 kHz this is a delay of 0 to 59.0 ms and at 48 kHz it is a
delay of 0 to 54.2 ms.
Delay can be applied to any of the input channels and the tape and effect
return channels. The stereo input channels are always ganged together. The
MIC/LINE and TAPE channels are set independently only when they are
not linked together in GANG mode with the PAN function
Delay and Cascade
If you use a digital cascade kit (CD8-CS) to connect more than four 02Rs
together, you will need to use the DELAY display function to apply delay
to the machines closest to the output. Set a delay value of 10 to 20 samples
for each unit.
The digital cascade kit will automatically apply the correct amount of delay
when you connect four or less 02Rs together. See “Cascade Configuration”
on page 191 of the User’s Guide.
Delay Pages
There are two pages to the DELAY 1/1 function. The first page, shown
below, contains the Delay controls for MIC/LINE channels 1 to 24, and
appears when one of these channels is selected.
1. Press the [DELAY] button.
The DELAY display
function appears.
2. Select a channel using
the [SEL] buttons or the
CURSOR buttons.
3. By default, the delay is
off. Press the [ENTER]
button to turn it on. The
OFF icon, highlighted,
changes to ON.
4. Use the CURSOR buttons
to select either [Smpl] or
[mSEC].
5. To change the delay,
rotate the encoder
wheel until the desired
value is shown.
6. To set all channels to the
same delay time,
double-click the
(ENTER) button.
DELAY