Yamaha NXY, User Manual, Page: 36 / 56

4-2
Chapter
4
INST
ALLING THE TOOL
2. ZFH (single arm type, double arm type)
When using the 3rd-axis model with ZFH for the 3rd-axis, install the workpiece onto the
ZFH slider by using four M5 coarse thread tap holes and a
φ
5 reamer hole opened on
the slider's workpiece installation surface. The tap depth is 9mm. There is a step on the
top of the slider. The actual tool installation surface is the shaded section shown in the
drawing.
62
100
11
2
SEC A-A
31 28 31
70
10.5
9 1
A
A
4-M5x0.8 Depth 9
2-
F
5H7 Depth 8
(Tolerance between knock (0.02)
c
CAUTION
If the bolt fi tting length is 9mm or more from the installation surface, the bolt will
contact the bottom.
2. ZFH (single arm type, double arm type)