21
En
Initial settings
PR
EPAR
ATIO
N
C
ONNE
CTIO
N/
INIT
IAL S
ETT
INGS
PLA
YBA
CK
S
ETTIN
GS
TRO
UBLE
S
HO
O
T
IN
G
APP
END
IX
■
Error messages for AUTO SETUP
If an error message is displayed on your TV, check the error
message list to solve the problem and then follow the procedure
below.
[ERROR E-1]
: Press
ENTER key to run the AUTO SETUP
procedure again. Or press
Z
key to continue the
measurement.
[ERROR E-7], [ERROR E-9]
: Press
key to turn this unit
to standby mode, then run AUTO SETUP procedure again after
turning this unit on.
Other errors
: Press
RETURN key to cancel the operation
and then run the AUTO SETUP procedure again.
If the problem is difficult to be solved, configure the settings
manually in “SETUP MENU” (
ERROR E-1: Please test in quieter environment.
Cause
Remedy
There is too much unwanted
noise in your listening room.
Make sure that your listening
room is as quiet as possible. You
may want to choose certain hours
during the day when there is not
much noise coming from outside.
ERROR E-2: No MIC detected. Please check MIC
connection and re-try.
Cause
Remedy
The IntelliBeam microphone is
not connected to this unit or
disconnected during the AUTO
SETUP procedure.
Connect the IntelliBeam
microphone to this unit firmly.
ERROR E-3: Unexpected control is detected. Please
re-try.
Cause
Remedy
Some other operations were
performed on this unit while the
AUTO SETUP procedure was in
progress.
Do not perform any other
operations while the AUTO
SETUP procedure is in progress.
ERROR E-4: Please check MIC position. MIC should
be set in front of the Sound Projector and re-try.
Cause
Remedy
The IntelliBeam microphone is
not placed in front of this unit.
Make sure that the IntelliBeam
microphone is installed in front
of this unit.
ERROR E-5: Please check MIC position. MIC should
be set above 1.8m/6.0ft and re-try.
Cause
Remedy
The IntelliBeam microphone is
not placed in the right distance
from this unit.
Make sure that the IntelliBeam
microphone is installed more
than 1.8 m (6.0 ft) from the front
of this unit and within 1 m (3.3
ft) from the center height of this
unit.
ERROR E-6: Volume level is lower than expected.
Please check MIC position/connection and re-try.
Cause
Remedy
The IntelliBeam microphone
cannot collect the sound
produced by this unit because the
sound output level is too low.
Make sure that the IntelliBeam
microphone is firmly connected
to this unit and placed in a proper
location. If the problem persists,
contact the nearest
authorized Yamaha service
center for assistance.
ERROR E-7: Unexpected error happened. Please
turn off and re-try.
Cause
Remedy
An internal system error
occurred.
Press
key to turn this unit
to standby mode, then run AUTO
SETUP procedure again after
turning this unit on.
ERROR E-9: Turn off and check the connection with
subwoofer.
Cause
Remedy
Subwoofer is not connected.
Press
key to turn this unit
to standby mode, connect the
subwoofer (
p. 13). After that,
run AUTO SETUP procedure
again.
