Yamaha NS-SWP600, Owner'S Manual

Page: 19 / 59

17
En
Initial settings
PR
EPAR
ATIO
N
C
ONNE
CTIO
N/
INIT
IAL S
ETT
INGS
PLA
YBA
CK
S
ETTIN
GS
TRO
UBLE
S
HO
O
T
IN
G
APP
END
IX
This unit creates a sound field by reflecting sound beams on the
walls of your listening room and by broadening the cohesion of
all the channels. Just as you would arrange the speaker position of
other audio systems, you need to set the beam angle to enjoy the
best possible sound from this unit.
This unit employs the beam optimization and sound optimization
features with the aid of the supplied IntelliBeam microphone, allowing
you to avoid troublesome listening-based setup and achieving highly
accurate sound adjustments that best match your listening
environment. We call these two features “
IntelliBeam ” generically.
Beam optimization:
This feature optimizes the beam angle so that the parameter best
matches your listening environment.
Sound optimization:
This feature optimizes the beam delay, volume, and quality so
that the parameters best match your listening environment.
This unit performs these two automatic optimizations with the aid
of the supplied IntelliBeam microphone.
2)
Auto setup for appropriate
surround effects (IntelliBeam)
Installing the IntelliBeam microphone
1
Place the IntelliBeam microphone on a flat
level surface at your normal listening position.
Use the supplied cardboard microphone stand or a tripod
to place the IntelliBeam microphone at the same height as
your ears would be when you are seated.
■
Assembling the supplied cardboard
microphone stand
•
The AUTO SETUP procedure may not be run successfully if this
unit is installed in one of the rooms described in “Installing this
unit” on page 11. In such cases, run MANUAL SETUP (
☞
p. 20)
to manually adjust the corresponding parameters.
•
Do not connect the IntelliBeam microphone to an extension cable
as doing so may result in an inaccurate sound optimization.
•
After you have completed the AUTO SETUP procedure, be sure
to disconnect the IntelliBeam microphone.
•
The IntelliBeam microphone is sensitive to heat.
– Keep the IntelliBeam microphone away from direct sunlight.
– Do not place the IntelliBeam microphone on top of this unit.
Notes
1 2 3
5 4
Remove
Fit in
Run
through
Place
horizontally
Fit in
Make sure that there are no obstacles between the
IntelliBeam microphone and the walls in your listening
room as these objects obstruct the path of sound beams.
However, any objects that are in contact with the walls
will be regarded as a protruding part of the walls.
2
Check if a video pin cable is connected.
IntelliBeam microphone Upper limit
Within 1 m (3.3 ft)
Center height of this
unit
Cardboard microphone
stand
Within 1 m (3.3 ft)
Listening
position
1.8 m (6.0 ft)
or more
Lower limit
Center line
IntelliBeam
microphone
Cardboard microphone stand
• “BEAM+SOUND OPTIMIZE” screen appears automatically when
the IntelliBeam microphone is connected. “BEAM OPTIMIZE
ONLY” or “SOUND OPTIMIZE ONLY” can be selected separately
in setup menu (
☞
p. 20).
• Data set automatically can be saved in the system memory (
☞
p. 22).
You can save the several data depending on listening room and you
can change the setting conveniently.
2)
y