Yamaha NS-F71, Owner'S Manual

Page: 5 / 22

3
En
Removing / Attaching the grille
English
■
Connecting to an amplifier
Connect each speaker to the appropriate speaker terminals on your
amplifier by using the cables you prepared earlier.
Please refer to the owner’s manual that came with your amplifier
or receiver.
The grille is fastened to the enclosure at six points and can be removed if desired. To remove the grille, hold on to
both sides and slowly pull straight away from the speaker. To reattach, line up the six holes on the inner surface of
the grille with the six corresponding pegs on the speaker and push gently.
• When removing or attaching the grille, be careful not to touch
the drive units, and not to exert excessive force with any tools.
• Do not touch or apply impact to the speaker’s diaphragm.
Otherwise, the speaker may malfunction.
• To avoid damaging the grille, never apply excessive force, and
be sure to use its frame, never pull or push the surface, for
removing or attaching the grille.
Type .................................................................... 2-way bass reflex
Magnetic shielding type
Driver ............................. Woofer: 16 cm (6-1/2") cone type x 2
Tweeter: 3 cm (1") soft dome type
Nominal input power ......................................................... 80 W
Maximum input power .................................................... 240 W
Impedance ............................................................... Nominal 6 Ω
Frequency response ............................................43 Hz - 26 kHz
Sensitivity .........................................................89 dB/2.83 V, 1 m
Dimensions (W x H x D)
.................... 233 x 974 x 258 mm (9-1/8" x 38-3/8" x 10-1/8")
Weight ................................................................ 13.7 kg (30.2 lbs)
* The contents of this manual apply to the latest specifications
as of the printing date. To obtain the latest manual, access
the Yamaha website then download the manual file.
SPEAKERS
A
B
L R
+
+
– –
Right Left
Amplifier
or Receiver
Speakers output
terminals
Banana plug
When using a banana plug
1
Tighten the terminal
knob.
2
Simply insert the
banana plug into
the terminal.
Removing / Attaching the grille
Specifications
Note
Taking care of the speaker
When you wipe this unit, do not use chemical solvents (e.g., alcohol or thinners, etc.): this might damage the
finish. Use a clean, dry cloth. For difficult soils, dampen a soft cloth in water, wring it out, and then wipe with the
cloth.
(For polish-finished model) Bumping the surface of the instrument with metal, porcelain, or other hard objects
can cause the finish to crack or peel.