Yamaha MusicCast WX-030, Owner'S Manual

Page: 21 / 179

TROUBLESHOOTING
18
En
Bluetooth
Problem Cause Solution
Cannot make this unit
paired with the connecting
device.
The connecting device does not support
A2DP. Perform pairing operations with a device
which supports A2DP.
The passkey of the devices, such as a
Bluetooth adaptor, that you want to pair
with this unit is other than “0000.”
Use a connecting device with a passkey
“0000.”
This unit and the connecting device are
too far apart. Move the connecting device closer to this
unit.
There is a device (microwave oven,
wireless LAN, etc.) that outputs signals in
the 2.4 GHz frequency band nearby. Move this unit away from the device that is
emitting radio-frequency signals.
The unit is in standby mode. Turn the unit on and perform pairing (
☞
P.11).
Another Bluetooth device is connected. Terminate current Bluetooth connection, and
perform pairing with the new device.
Cannot establish a
Bluetooth connection.
This unit is not registered on the connecting
device’s
Bluetooth connection list.
Perform pairing operations again (
☞
P.11).
The unit is in Eco Standby mode. Turn the unit on, then establish a Bluetooth
connection (
☞
P.11).
Another Bluetooth device is connected. Terminate current Bluetooth connection, then
establish a Bluetooth connection with that
device again.
The Bluetooth function of the device is
turned off.
Turn on the Bluetooth function of the device.
The pairing information has been deleted. Perform pairing again (
☞
P.11).
This unit can be paired with up to 20 devices.
(Depending on the conditions of use, the
maximum number of devices the unit can
connect decreases.). If pairing with the 21st
device is performed, the pairing information
with the oldest connection date will be
deleted.
Delete any pairing history of WX-030 on the
iPhone/iPad/iPod touch, then pair with the
WX-030 again (
☞
P.11).
No sound is produced or
the sound is interrupted
during playback. The Bluetooth connection of this unit with
the connecting device is disconnected.
Perform Bluetooth connection operations
again (
☞
P.11).
This unit and the connecting device are
too far apart. Move the connecting device closer to this
unit.
There is a device (microwave oven,
wireless LAN, etc.) that outputs signals in
the 2.4 GHz frequency band nearby. Move this unit away from the device that is
emitting radio-frequency signals.
The connecting device’s Bluetooth
function is off.
Turn on the Bluetooth function of the
connecting device.
The connecting device is not set to send
Bluetooth audio signals to this unit.
Check that the Bluetooth function of the
connecting device is set properly.
The pairing setting of the connecting
device is not set to this unit. Set the pairing setting of the connecting
device to this unit.
The connecting device’s volume is set to
the minimum. Increase the volume level.
The connecting device is connected to
more than two
Bluetooth devices and this
unit (WX-030) is not selected as a
playback device.
Select this unit as a playback device for the
connecting device.