12
En
OTHER FUNCTIONS AND INFORMATION
You can use two WX-030 units to reproduce stereo sound by setting each speaker as the right
or left speaker.
Set the left and right speakers separately by following the steps below.
A
Connect each WX-030 to the same network by using the dedicated app “MusicCast
CONTROLLER.”
If the WX-030 is linked to another MusicCast unit, first disconnect the link by using the dedicated app “MusicCast
CONTROLLER.”
B
Tap
(power)/CONNECT
of each unit to set them to standby mode.
C
Tap and hold the following together for 3 seconds to set the left/right speakers.
1
For setting the left speaker:
and
Indicators light from right to left repeatedly (refer to
of the table), and the unit enters pairing standby
mode.
2
For setting the right speaker:
and
Indicators light from left to right repeatedly (refer to
of the table), and the units start pairing.
Indicator display during the Stereo Pair
After paring is completed, the indicators light from the center to both sides (refer to
of the table), and all indicators
return to the normal status.
STEREO PAIR
• To use the Stereo Pair function, you need two
WX-030.
• Before setting the Stereo Pair, update the
dedicated app “MusicCast CONTROLLER”
and the firmware of both units to the latest
version (
P.7).
• Stereo Pair function does not support AirPlay.
• Stereo Pair is available only when the
Network Standby mode of the unit is enabled.
Setting/Playing back music
WX-030
Left
speaker
WX-030
Right
speaker
Note
Stereo Pair
status
Indicator display
Start Pairing/
Checking the
Left and Right
Speaker
Pairing
Completed
Left speaker
Right speaker
Right-to-Left
Left-to-Right
Center to both sides
Summary of Contents for MusicCast WX-030
Page 178: ......
