35
English
B
Select the desired Variation Type.
Use the VALUE buttons. For a list of the available Variation Types,
see page 60.
N
Set the Send Level control to the desired value.
Once you’ve selected a Variation Type to your satisfaction, you can
re-adjust the effect level for the selected Part (and other Parts, too).
To do this, repeat steps #1 and #3 above.
M
Set the Dry Level control to the desired value.
This parameter gives you additional fine control over the Variation
effect balance. Setting this to a low value turns down the level of
the “dry” sound and emphasizes the Variation effect sound.
To do this, simultaneously hold down the PLAY/EDIT button and
press the DRY LVL button, and then set the value by using the
VALUE buttons.
P l a y i n g t h e M U 1 5
DryLevel
Using the “INS” (Insertion) Setting
The “INS” (Insertion) setting lets you dedicate the Variation
effect to a single selected Part.
NOTE
•
For the “INS” setting, the Send Level parameter can only be
turned on or off for the selected Part, and the Dry Level
parameter is unavailable.
1)
Select the desired Part.
2)
Set Variation Connection to “INS.” Simultaneously hold
down the PLAY/EDIT button and press the INS SYS button,
and then press the VALUE
/NO button.
3)
Set the Send Level for the Part to “on.” Simultaneously
hold down the PLAY/EDIT button and press the VARIATION
SEND LVL button, and then press the VALUE
/YES button.
4)
Select the desired Variation Type in the same way as
described in steps #4 and #5 in the main instructions above.
