Special features
4-3
1
2
3
4
5
6
7
8
9
10
11
12
Resetting the traction control sys-
tem
The traction control system will auto-
matically disable when:
the front wheel or rear wheel
comes off the ground while riding.
excessive rear wheel spin is de-
tected while riding.
either wheel is rotated with the key
turned to “ON” (such as when per-
forming maintenance).
If the traction control system is dis-
abled, both the “
” indicator light and
the “
” warning light will come on.
Should this occur, try resetting the sys-
tem as follows.
1. Stop the vehicle and turn the key
to “OFF”.
2. Wait a few seconds and then turn
the key back to “ON”.
3. The “
” indicator light should turn
off and the system be enabled.
TIP
If the “
” indicator light remains on af-
ter resetting, the vehicle may still be rid-
den; however, have a Yamaha dealer
check the vehicle as soon as possible.
4. Have a Yamaha dealer check the
vehicle and turn off the “
” warn-
ing light.
EAU76401
Quick shift system
The quick shift system (QS) allows for
full-throttle, clutch lever-less, electroni-
cally-assisted upshifts. When the shift
switch detects motion in the shift pedal
(page 5-14), engine power and drive
torque are momentarily adjusted to al-
low the upshift to occur.
TIP
The quick shift system operates
when traveling at least 20 km/h (12
mi/h) with an engine speed of 2300
r/min or higher, and only when ac-
celerating.
It does not operate when the clutch
lever is pulled.
BS2-28199-20.book 3 ページ ２０１６年９月２９日 木曜日 午後５時１５分
