Yamaha MTN1000 2016, Service Manual

Page: 207 / 658

REAR WHEEL
4-36
2. Replace:
•
Rear wheel sprocket
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the rear wheel sprocket nuts and the
rear wheel sprocket.
b. Clean the rear wheel drive hub with a clean
cloth, especially the surfaces that contact the
sprocket.
c. Install the new rear wheel sprocket.
TIP
Tighten the rear wheel sprocket nuts in stages
and in a crisscross pattern.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30163
ASSEMBLING THE REAR WHEEL
NOTICE
ECA21340
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
1. Install:
• Wheel bearings
• Oil seal
Refer to “ASSEMBLING THE FRONT
WHEEL” on page 4-25.
2. Install:
• Wheel bearing ring nut
TIP
Apply locking agent (LOCTITE®) onto the two
symmetric places on the circumference of the
threads of the wheel bearing ring nut.
3. Tighten:
•
Wheel bearing ring nut “1”
TIP
Use the wheel bearing ring nut tool “2” to tighten
the wheel bearing ring nut by turning it counter-
clockwise “a”.
b. Correct
1. Drive chain roller
2. Rear wheel sprocket
Rear wheel sprocket nut
80 N·m (8.0 kgf·m, 58 lb·ft)
T
R
.
.
New
a. Width: two grooves of the threaded portion
b. Length: more than 40 mm (1.57 in)
Wheel bearing ring nut tool
90890-01574
YM-01574
Wheel bearing ring nut
80 N·m (8.0 kgf·m, 58 lb·ft)
LOCTITE®
New
a
b
LT LT
T
R
.
.