Perio
d
ic maintenance an
d
a
d
justment
7-34
7
4. Insert a new bulb into the socket.
5. Install the socket (together with
the bulb) by pushing it in, and then
turning it clockwise until it stops.
6. Place the license plate light unit in
the original position, and then in-
stall the collars and bolts.
EAU67131
Supportin
g
the motorcycle
Since this model is not equipped with a
centerstand, use maintenance stands
when removing the front or rear wheel
or when performing other maintenance
that requires the motorcycle to stand
up right.
Check that the motorcycle is in a stable
and level position before starting any
maintenance.
EAU25872
Trou
b
leshootin
g
Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur
during operation. Any problem in the
fuel, compression, or ignition systems,
for example, can cause poor starting
and loss of power.
The following troubleshooting charts
represent quick and easy procedures
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
WARNING
EWA15142
When checkin
g
the fuel system,
d
o
not smoke, an
d
make sure there are
no open flames or sparks in the ar-
ea, inclu
d
in
g
pilot li
g
hts from water
1. License plate light bulb
1
1. Maintenance stand (example)
1
UBAT10E0.book Page 34 Friday, November 6, 2020 6:08 PM
