Instrument and control functions
4-33
1
2
3
4
5
6
7
8
9
10
11
12
EAU57991
Seat
To remove the seat
1. Open the seat lock cover, insert
the key into the seat lock, and then
turn the key counterclockwise.
2. While holding the key in that posi-
tion, lift the rear of the seat up, and
then pull the seat off.
To install the seat
1. Insert the projections into the seat
holders as shown.
2. Push the rear of the seat down to
lock it in place.
3. Remove the key.
TIP
Make sure that the seat is properly se-
cured before riding.
EAU67383
Adjusting the front fork
This model is is equipped with ÖHLINS
electronic racing suspension.
The compression and rebound damp-
ing forces are electronically adjusted.
(See ERS on page 4-16.)
NOTICE
ECA22471
Use extra care to avoid scratch-
ing the gold-anodized finish
when making suspension ad-
justments.
To avoid damaging the suspen-
sion’s internal mechanisms, do
not attempt to turn beyond the
maximum or minimum settings.
Spring preload
The spring preload adjustment is per-
formed manually.
1. Turn the vehicle off.
2. Slide the rubber cover back at
each coupler.
3. Remove the coupler on each front
fork.
NOTICE:
To prevent dam-
aging the couplers, do not use
sharp tools or excessive
1. Seat lock
2. Seat lock cover
3. Unlock.
1
3
2
1. Projection
2. Seat holder
2
2
1
BW8-9-E0_1.book 33 ページ ２０１６年１２月１３日 火曜日 午前１０時３９分
Summary of Contents for MT-10 SP 2016
Page 116: ...BW8 9 E0_1 book 3...
Page 117: ...BW8 9 E0_1_Euro_E_Hyoshi indd 3 2016 12 13 11 10 32...
