Special features
4-4
1
2
3
4
5
6
7
8
9
10
11
12
TIP
The current drive mode is shown in
the drive mode display (page
5-10).
The current drive mode is saved
when the vehicle is turned off.
EAU73914
Traction control system
The traction control system (TCS)
helps maintain traction when accelerat-
ing on slippery surfaces, such as un-
paved or wet roads. If sensors detect
that the rear wheel is starting to slip (un-
controlled spinning), the traction control
system assists by regulating engine
power as needed until traction is re-
stored.
WARNING
EWA15433
The traction control system is not a
substitute for riding appropriately
for the conditions. Traction control
cannot prevent loss of traction due
to excessive speed when entering
turns, when accelerating hard at a
sharp lean angle, or while braking,
and cannot prevent front wheel slip-
ping. As with any vehicle, approach
surfaces that may be slippery with
caution and avoid especially slip-
pery surfaces.
With the throttle closed, push this
switch down to change from TCS “1” or
“2” to “3”. Push up to change from TCS
“3” or “2” to “1”.
With the vehicle stopped, push this
switch up for two seconds to turn the
system off. Push down to turn the sys-
tem on.
TIP
The current TCS setting is shown in the
TCS display (page 5-10).
1. Traction control system switch “TCS”
RE
S
SE
T
PA
SS
TCS
SELECT
1
B67-9-13.book 4 ページ ２０１９年７月１９日 金曜日 午後２時５６分
