3
Satellite speaker
1.
First insert the speaker mount of the satellite speaker
into the hole
q
of the pipe clamp, then tighten the wing
bolt.
2.
As shown in Figure A, slowly insert one leg of your drum
rack through the hole
w
of the pipe clamp. When you
finish adjusting the position, tighten the wing bolt as
shown in Figure B.
3.
See Figure C. Place the Subwoofer speaker on a flat
floor.
4.
Connect the satellite speakers, subwoofer speaker, and
the drum module via the included combination cable as
shown in Figure C.
Installing the Monitor Speakers
y
[Rear]
y
[INPUT] jack
This jack is used to connect the satellite
speaker to the subwoofer.
CAUTION
The MS45DR satellite speakers can be attached to straight vertical pipes of 1.5-inch (38.1-mm) diameter. These speakers cannot be
attached to curved pipes or any pipes of different diameter sizes.
CAUTION
Be sure to attach the satellite speakers to the leg of the
drum rack slowly and deliberately to avoid injury.
Be sure to tighten the wing bolts securely.
Wing bolt
Pipe clamp
q
Speaker mount
Satellite speaker
NOTE
[Figure A]
[Figure B]
Wing bolt
Drum rack leg
w
WARNING
Use only the supplied power cord.
CAUTION
When setting up the product, make sure that the AC out-
let you are using is easily accessible. If some trouble or
malfunction occurs, immediately turn off the power
switch and disconnect the plug from the outlet.
Summary of Contents for MS45DR
Page 14: ...7 MEMO ...
