Mobile Music Sequencer Owner’s Manual
12
Editing Phrases
Any phrase from the Phrase Viewer can be edited using the Loop Remix Editor,
Source Chord Editor, Phrase Voice Setup Editor, and Other Setting Editor as
follows.
1. Tap [VIEW] from the PHRASE menu to open the Phrase
Viewer.
2. In the Phrase Viewer, tap a phrase to select it for editing.
3. Tap [EDIT] from the PHRASE menu.
4. Tap the required editor in the PHRASE EDIT menu.
5. Tap [SAVE] to save any changes you have made to the
phrase.
REMIX
The Loop Remix Editor can be opened by tapping
[REMIX]
in Step 4 above.
3
4
1
2
5
6
1
Area
1
is used to select the remix mode.
2
In Area
2
, you can select a variation for the remix mode from Area
1
.
3
Use Area
3
to set the measures to be remixed. You can also tap [ALL ON]
to remix all measures or [ALL OFF] to clear the current selection.
4
Area
4
is used to select a remix type. The bar below the type number
corresponds to one measure, and the lines show the remix points within
the measure. By changing the type, therefore, you can remix the phrase at
different points.
1. Select from NORMAL, BREAK, ROLL, and FILL remix modes in
Area
1
.
2. Tap a number to select a variation in Area
2
.
The phrase will be remixed based on the selected mode and variation, and the
remixed phrase will be played.
You can tap [ORIGINAL] in Area
5
to restore the phrase to its original condition
before remixing. In addition, you can tap the [DICE] in Area
6
to randomize the
variation selected in Area
2
.
