3. Setting Up
MMP1 Operation Manual
5
3. Setting Up
3-1. Open the application
3-1-1. MMP1 Editor
Click or double click the MMP1 icon.
3-1-2. MMP1 Controller
Tap the MMP1 Controller icon.
3-2. Log in (MMP1 Editor only)
3-3. Select an MMP1
3-3-1. MMP1 Editor
Select an MMP1 on the “Select MMP1” dialog box.
NOTE
You can also display the “Select MMP1” dialog box from the
menu bar to change the desired MMP1 for operation at any time.
User Type
You can restrict the MMP1 Editor operations
according to their User Type. The following
three User Types are available.
Administrator
Allows unrestricted access to all screens
and functions.
Advanced User
Allows access to almost all functions
besides settings (Settings screen).
Basic User
Allows access only to the Main screen and
the Information screen.
Password
Enter your password to log in as an
“Administrator” or “Advanced User.”
NOTE
• “Administrator” and “Advanced User”
passwords can be set on the “Editor” tab
of the Settings screen.
• Passwords are left blank by default when
unset.
Online
Opens the “Select MMP1” dialog box for
selecting desired MMP1.
Offline
Edits the MMP1 Editor offline without
connection to or control of the MMP1.
Exit
Closes the MMP1 Editor.
NIC
Select the network interface card
connected to the MMP1 to operate.
Device
Select the MMP1 to operate. Click the
asterisk (*) in the Identify column so that the
indicator on the front panel of the
corresponding MMP1 flashes on and off.
OFFLINE
Disconnects from the MMP1 and closes the
“Select MMP1” dialog box.
CONNECT
(Editor
MMP1)
Connects to the MMP1 selected in the
Device field and sends MMP1 Editor
settings to the MMP1. The “Select MMP1”
dialog box will close after settings are sent.
NOTE
You must enter the Passcode for the MMP1
when connecting to an MMP1 with a
Passcode set. You can set Passcodes on
the Information screen when logged in as
an Administrator. Entering a passcode is
not necessary when connecting to the
same MMP1 as that used previously.
CONNECT
(MMP1
Editor)
Connects to the MMP1 selected in the
Device field and loads MMP1 settings into
the MMP1 Editor. The “Select MMP1” dialog
box will close after settings are retrieved.
NOTE
You must enter the Passcode for the MMP1
when connecting to an MMP1 with a
Passcode set.
You can set Passcodes on the Information
screen when logged in as an Administrator.
Entering a passcode is not necessary when
connecting to the same MMP1 as that used
previously.
