4. Screens
MMP1 Operation Manual
48
Common items for all tabs
COMMON tab
Channel name
Displays the channel name.
NOTE
The channel name can be set in the MMP1
Editor.
Shows the status of mics controlled with the
Commentary functions.
Shows the mic audio is being input.
Shows that the mic user has muted
mic audio.
Shows that the mic on and off
control by the mic user is disabled.
NOTE
When the Commentary functions are not
being used, you can hide the functions using
“Show Cough Status” on the Preference
screen.
SOURCE A/
SOURCE B
Switches between channel strip input
sources.
Switches between the signal phases
(normal phase/reversed phase (green)).
INSERT
Turns Insert on (green) or off.
Send Destination
Select the signal to send to the Insert.
Return Source
Select the signal to be returned from the
Insert.
(Insert) Trim
Drag to adjust signal levels to be sent to
the Insert. Double tap to return this value
to 0.
SIGNAL CHAIN
Displays the signal processors applied to
audio signals in the order in which they
are applied (descending order).
Trim
Drag to adjust the output level for the
selected channel. Double tap to return
this value to 0.
PFL
Turns output to the PFL (Pre Fader Listen)
bus on (green) or off. Turn this on to send
pre fader audio signals to Main Monitors
1 and 2 while muting outputs from Main
Monitor 3 onwards.
AFL
Turns output to the AFL (After Fader
Listen) bus on (green) or off. Turn this on
to send post fader audio signals to Main
Monitors 1 and 2 while muting outputs
from Main Monitor 3 onwards. When
“PFL” is on, signals will not be sent to the
Main Monitors even when this button is
turned on.
MUTE
Turns mute on (yellow) or off.
Drag to change the pan. Double tap to
return this value to C.
PRE
POST
Tap to change the position (pre fader/
post fader) of the signal displayed on the
meter.
Level meter
Values less than -20 dB are displayed in
green
, values less than 0 dB in
yellow
, and values equal to or above
that in red
. Peak hold circuits are not
displayed. Whether pre fader or post
fader values are displayed is changed
using “
PRE
”
and
“
POST
.”
Fader
Drag to set the level.
Output level
Displays the output level.
