Controls and Connectors
MGP16X/MGP12X Owner’s Manual
24
SEND MASTER section
q
SEND MASTER controls (AUX1, AUX2, FX1,
FX2)
These adjust the signal level sent to the AUX, AUX2, FX1
and FX2 SEND jacks.
NOTE
These SE
N
D MASTER controls do not affect the level of the
signal sent from the internal digital effect to the FX1 and FX2
buses.
w
AFL switch and indicator
When the AFL (After-Fader Listen) switch is on, the indica-
tor lights and the signal after the AUX1 and AUX2 controls
(
q
) adjustment is output to the MONITOR OUT and
PHONES jacks for monitoring.
NOTE
• The PFL signal has priority when both the PFL switch and
AFL switch are on. To monitor the post-fader signal, make
sure to turn off all PFL switches.
• If the PFL (preferred) is enabled, the AFL indicator does not
light, even if the AFL switch is pressed.
GROUP/STEREO section
q
GROUP 1-2 fader
Adjusts the signal level to the GROUP OUT 1 and GROUP
OUT 2 jacks.
w
GROUP 3-4 fader
Adjusts the signal level to the GROUP OUT 3 and GROUP
OUT 4 jacks.
e
ST switch
If this switch is on, the signals are sent to the STEREO L/R
bus via the GROUP1-2 or 3-4 fader. The Group 1 and 3 signal
goes to Stereo L and the Group 2 and 4 signal goes to Stereo
R.
r
AFL switch and indicator
When the AFL (After-Fader Listen) switch is on, the indica-
tor lights and the signal after GROUP 1-2 (
q
) or 3-4 (
w
)
faders adjustment is output to the MONITOR OUT and
PHONES jacks for monitoring.
NOTE
• The PFL switch has priority when both the PFL switch and
AFL switch are on. To monitor the post-fader signal, make
sure to turn off all PFL switches.
• If the PFL is enabled (preferred), the AFL indicator does not
light, even if the AFL switch is pressed.
t
ON switch
Turn this switch on to enable the STEREO master fader. The
switch lights when on.
y
STEREO master fader
Adjusts the signal level sent to the STEREO OUT jacks.
w
q
y
q
r
e
w
t
