16
MG124CX/MG124C Owner’s Manual
Front & Rear Panels
Reference
DIGITAL EFFECT
*Only the MG124CX has digital effects.
1
FOOT SWITCH Jack
A YAMAHA FC5 foot switch (sold separately) can be connected to this
jack and used to toggle the digital effects ON and OFF.
2
PROGRAM Dial
Selects one of the 16 internal effects. See page 17 for details about the
internal effects.
3
PARAMETER Control
Adjusts the parameter (depth, speed, etc.) for the selected effect.
The last value used with each effect type is saved.
When you change to a different effect type, the mixer automat-
ically restores the value that was previously used with the
newly selected effect (regardless of the current position of the
PARAMETER Control knob).
These parameter values are reset when the power is turned off.
4
AUX Control
Adjusts the level of the signal sent from the internal digital effect unit to
the AUX bus.
5
ON Switch
Switches the internal effect on or off. The internal effect is applied only
if this switch is turned on. The switch lights orange when on.
An optional YAMAHA FC5 foot switch (sold separately) can be used to
toggle the digital effects ON and OFF.
The ON switch lights and the internal effect unit is active by
default when the power is initially turned on.
6
PFL Switch
Turn this switch on to send the effect signal to the PFL bus.
7
EFFECT RTN Fader
Adjusts the signal level sent from the internal digital effect unit to the
STEREO bus.
Rear Input/Output Section
1
POWER Switch
Use this switch to turn the mixer’s power ON or to STANDBY mode.
2
AC ADAPTOR IN Connector
Connect the supplied PA-20 power adaptor to this connector (see page
5).
Note that a small current continues to flow while the switch
is in the STANDBY position. If you do not plan to use the
mixer for a while, be sure to unplug the AC adaptor from the
wall outlet.
Use only the PA-20 adaptor included with this mixer. Use of
a different adaptor may result in fire or electric shock.
ON
4
3
5
7
2
6
1
MG124CX
NOTE
NOTE
1
2
CAUTION
CAUTION
