
MG10/2
11
Power switch and AC connector wiring
(電源スイッチとACコネクタの結線)
(a). Twist Wiring Assy AC8 three times,and fix to a top cover.
束線AC8 を3回捻り、トップカバーに固定します。
(b). Adjust the position so that the wire is arranged within the range
of the PWB print (reticulation).
線材が、基板印刷(網目)の範囲内に配置されるように位置を調整します。
(c). Fix the wire by pasting the filament tape to the position of figure.
図の位置にフィラメントテープを貼り、線材を固定します。
* Note that the wire (black) doesn't shut the hole that tightens the screw.
この時、線材(黒)が、ネジ締め穴を塞がないように注意してください。
Top Cover
WA595401 (Connector 3P BROWN, RED, BLACK)
(c) VA126400 (Filament Tape)
(熱収縮チューブ:7箇所)
WB071100 (Shrink Tube Black : 7 places)
V3272800 (Cord Holder)
(a) WD350000 (Connector Assembly AC8 3P BROWN, RED, BLACK)
* Hole of Screw
(b) Reticulation
(網目)
WE521400 (MAIN circuit board)
• Rear view
• Top view
• Right side view
■
CIRCUIT BOARD LAYOUT & WIRING
(ユニットレイアウト & 結線図)