Setting Up
MG10/2
22
• When using the mixer on a microphone stand, be
sure to set the stand on a level and stable surface.
Do not set up the stand in locations subject to
vibrations or wind.
• Note that mixer may be damaged if the stand
should fall over. Attach the connection cables care-
fully so that the cables will not catch on the equip-
ment and cause it to fall. For example: arrange the
cables so that they run parallel with the micro-
phone pole down to the base of the stand.
• Leave ample free space around the stand.
(1) Turn the mixer upside-down, and hold the microphone-stand
adaptor (BMS-10A; sold separately) against the bottom of the
mixer so that the screw holes are aligned (
1
).
Screw the adaptor firmly into place with the two screws (
2
).
(2) Turn the mixer right-side up, and mount it onto your micro-
phone stand.
(3) Loosen the angle adjustment wingnut (
1
), adjust the mixer’s
angle as desired (
2
), and then tighten the wingnut securely (
3
).
For more information, refer to the BMS-10A Owner’s Manual.
Mounting to a Microphone Stand
1
2
1
3
2
