TROUBLESHOOTING
16
En
The following status messages appear only if you are using MCR-140.
The following LED statuses of the status indicator refer to the transmitter.
Status message
Cause
Remedy
page
iPod Linked
iPod
Wireless connection was successful.
iPod Unlinked
Wireless connection has disconnected.
Connect the iPod to the transmitter and start
playback.
iPod Low Batt.
The battery of the iPod is getting flat.
Set it in the charging cradle.
LED status
Transmitter status
Remedy
page
Off
The transmitter is in standby mode.
An iPod is not connected or wireless
communication has not been established.
Flashes green
Connection in progress.
Please wait.
—
Flashes green once
Adjusting the volume level or operating
with the remote control.
Lights up green
Wireless communication between the
unit and transmitter is established.
Lights up green and
flashes red for 2
seconds
An unsupported iPod is connected.
Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
Lights up green and
keeps flashing red
Connection failed.
Connect again.
Flashes red
Error occurs.
Remove the iPod from the transmitter, and connect
again.
Flashes red once
The volume of the unit is set to maximum
or minimum.
Flashes red 2 times
continuously
(regardless of green
status)
The battery of the iPod is low.
Set the iPod in the charging cradle.
Summary of Contents for MCR-140
