![background image](http://html2.mh-extra.com/html/yamaha/ls9-16/ls9-16_owners-manual_3201257032.webp)
LS9 Editor Owner’s Manual
32
K
KEY IN SOURCE
Click this to select one of the following signals to use as the key-in source.
L
CUE
This button cue-monitors the currently selected key-in signal. This is not shown in the ADDITIONAL VIEW.
M
KEY IN FILTER
Select the type of filter applied to the selected key-in signal; HPF (high pass filter), BPF (band pass filter), or LPF
(low pass filter). The ON/OFF button switches the filter on/off.
If you’ve selected BPF, use the two knobs to adjust the band pass frequency and Q. If you’ve selected HPF or LPF,
use the knob to adjust the cutoff frequency.
If COMPRESSOR is selected
A
TYPE
Indicates the type of the currently selected compressor.
B
LIBRARY
This button accesses the dynamics library. Clicking this button will open the DYNAMICS page of the LIBRARY
window.
C
ON
This button switches the compressor on/off.
D
Response curve
Indicates the response for the compressor of the currently selected channel.
E
GR meter
This meter indicates the amount of gain reduction produced by the compressor.
F
THRESHOLD
Specifies the threshold level at which the compressor will operate. The input signal will start being compressed
when the key-in signal exceeds this level; compression will be removed when the signal falls below this level.
G
RATIO
Specifies the ratio at which the input signal will be compressed when the key-in signal exceeds the threshold.
SELF PRE EQ
The pre-EQ signal of the currently selected input channel
SELF POST EQ
The post-EQ signal of the currently selected input channel
MIX OUT 13–16
The output signal of the corresponding MIX channel immediately before the output
attenuation
CH 1–64 POST EQ
The post-EQ signal of the corresponding input channel (however, you can only choose
channels belonging to the same group, within the nine groups CH1–8, CH9–16, CH17–
24, CH25–32, CH33–40, CH41–48, CH49–56, CH57–64 and STIN1L–STIN4R).
STIN1L–STIN4R POST EQ
1
4
J
7
8
6
9
K
2
3
5
L