![background image](http://html2.mh-extra.com/html/yamaha/loopfactory-an200/loopfactory-an200_manual_3217778045.webp)
45
Parameters /
Detail Parameter Tab
• Src1 (FM Depth Ctrl)
Settings: Fixed, PEG, FEG, LFO1, LFO2
This determines the modulation source which controls the
. When this is set to
"Fixed," there is no change in modulation over time.
• Src2 (Modulator)
Settings: VCO2 Frequency, VCO1, VCO1 Sub Osc. (sub oscillator), PEG,
FEG, LFO1, LFO2, VCO2 Output
This determines the source wave which modulates the VCO1 wave.
• For the most part, the above settings should be self-explanatory. If necessary, refer to the rel-
). The other settings are explained
below.
VCO2 Frequency : This modulation uses a sine wave which is set to the same frequency as
that of the VCO 2’s pitch.
VCO1 Sub Osc. :
This modulation uses a wave of either half or double the frequency of the
VCO 1 (depending on the selected VCO 1 waveform).
VCO2 Output :
This uses the actual VCO 2 output waveform for modulation, resulting in
an FM synthesis-like sound.
Output Gain
Settings: +0 dB, +6 dB, +12 dB
This determines the overall level gain of the output signal of the selected pattern. Use
this parameter together with the hardware VOLUME control on the tone generator to set
the desired pattern level.
• Be careful when using the higher settings, since you may inadvertently damage the con-
nected audio equipment (and your ears!) if the pattern is too loud.