43
Parameters /
Detail Parameter Tab
• Key On Resett
Settings:
Off:
LFO 1 and LFO 2 do not reset, but modulate continuously.
On:
LFO 1 and LFO 2 reset every time a key is pressed.
This determines the start point of the LFO 1 and LFO 2 cycle.
• Sync Pmod Sw.
Settings: Master, Slave, Both
The Sync Pitch Modulation Switch setting determines which oscillator (master, slave, or
both) is modulated by the LFO 1 or LFO 2. Depth rate is determined by the
setting. This parameter is effective when the
is set to “VCO1 Master
> Slave.”
EQ Parameters
• Low Freq. (Low Frequency)
Range: 32 Hz ... 2.0 kHz
This determines the frequency which is boosted or cut with the
parameter in the
main control panel.
• High Freq. (High Frequency)
Range: 500 Hz ... 16.0 kHz
This determines the frequency which is boosted or cut with the
parameter in the
main control panel.
• Mid Freq. (Mid Frequency)
Range: 100 Hz ... 10.0 kHz
This determines the frequency which is boosted or cut with the
parameter in the
main control panel.
• Mid Resonance
Range: 1.0 ... 12.0
This determines the width of the frequency band which is boosted or cut with the
parameter in the main panel. The central frequency is set with the Mid Frequency
parameter (above). Higher values result in a narrower band width.
