52
En
Operating various settings for this unit (Setup menu)
MAC Address 1-10
Specify MAC addresses of network devices that are
permitted to access to this unit when “MAC Address
Filter” is set to “On”.
■
Network Standby
Selects whether or not to accept the commands via
network when this unit is on standby.
y
•
When “Network Standby” is set to “On”, the amount of power
consumption in the standby mode increases.
■
Information
Displays the network parameters (IP address, etc.) or
vTuner ID assigned to this unit.
Although the field sound programs would satisfy you as
they are with the default parameters, you can arrange
sound effect or decoders suitable for acoustical conditions
of sources or rooms by setting the parameters.
1
Press
j
Cursor
k
/
n
to select “DSP
Parameter” and then press
j
ENTER
.
2
Press
j
Cursor
k
/
n
to select “Program
Name” and then press
j
Cursor
l
/
h
to
select a sound field program to edit.
3
Press
j
Cursor
k
/
n
to select a parameter to
edit and then press
j
Cursor
l
/
h
to
change the setting.
y
•
Repeat steps 2 and 3 to change other sound field program
parameters.
DSP Level
Fine adjusts an effect level (level of the sound field effect
to be added). You can adjust the level of the sound field
effect while checking sound levels. Adjust “DSP Level” as
follows.
•
The effect sound is too soft.
•
There are no differences between effects of the sound
field programs.
→
Increase the effect level.
•
The sound is dull.
•
The sound field effect is added too much.
→
Reduce the effect level.
On
Permit access to this unit only from network
devices with the specified MAC addresses.
Choices:
Off*, On
Off
Not accept the commands via network.
On
Accept the commands via network.
DSP Parameter
To initialize the parameters of the selected sound field
program, press
j
Cursor
n
repeatedly to select
“Initialize” and then press
j
Cursor
h
. Then, press
j
Cursor
h
again to execute the initialization or
j
Cursor
l
to cancel it.
CINEMA DSP basic parameters
Adjustable range:
–6dB to 0dB* to +3dB
Sci-Fi
PLIIx Movie
0dB
16ms
1.0
2ms
1.0
DSP Parameter
Program Name
Decode Type
DSP Level
P. Initial Delay
P. Room Size
Sur. Initial Delay
Sur. Room Size
Sound field parameters
Set values
Sound field program
