16
RX-V495/RX-V495RDS/HTR-5140/HTR-5140RDS
Caution :
Before setting to the PRESET RESERVED, write down the existing preset memory contents of the Tuner
in a table as shown below. (This is because setting to the PRESET RESERVED will cause the memory
contents to be as factory set,i.e., all the preset memory by the user will be erased.)
Page
P1
P2
P3
P4
P5
P6
P7
P8
A
B
C
D
E
No.6 DISPLAY CHECK
Check program for FL display. The display status will change as follows with submenu operation. The signal is
processed with EFFECT OFF.
All segments are turned on and off to detect defects in the FL driver and FL display segments. Then the FL driver
operation is checked by the dimmer control.
Finally, all segments are turned on and off alternately (in lattice form), to check for a short-circuit between adjacent
segments.
No.7 MANUAL TEST
The noise generator built into the DSP outputs test noise from the channel specified by the submenu.
No.8 FACTORY PRESET
The menu is used to reserve whether or not to set the back-up data for the effect level, delay time and so on to the
factory preset state. The Signal is processed with EFFECT OFF.
1.INHIBIT:
The back-up data is not initialized.
To keep the data setby the user, check that this mode has
been selected and cancel the self diagnosis function.
2.RESERVED:
When the self diagnosis function is canceled, the back-
up data is initialized to the factory preset state.
For the contents of the initialization, refer to page 20.
The protection data is also reset.
6 DVD/LD
DISP CHECK
6 DVD/LD
9809161840
7 DVD/LD
TEST ALL
7 DVD/LD
TEST MAINR
7 DVD/LD
TEST LFE
8 DVD/LD
PRESET INH
8 DVD/LD
PRESET RES
7 DVD/LD
TEST MAINL
7 DVD/LD
TEST REARR
7 DVD/LD
TEST CNTR
7 DVD/LD
TEST REARL
Initial display.
All segments are turned off
All segments are turned on
Segments ON in a lattice.
Release date displayed.