En
13
CONNECTIONS
Connecting speakers
■
Connecting the subwoofer
1
Connect the subwoofer input jack to the
SUBWOOFER jack on this unit with an audio pin
cable.
2
Set the subwoofer volume as follows.
Volume: Set to approximately half volume (or slightly less than
half).
Crossover frequency (if available): Set to maximum.
■
Bi-amp connection for front speakers
This unit can connect speakers that support bi-amp connections.
When connecting speakers, connect the FRONT jacks and the
SURROUND BACK/BI-AMP jacks as in the diagram below.
To activate a bi-amp connection, connect the power cable, and then
set the following.
1
Check that the unit power is in standby mode.
2
Press
A
while pressing and holding STRAIGHT on
the front panel.
Release the keys when “ADVANCED SETUP” is displayed on
the front panel display. After approximately a few seconds, the
top menu items are displayed.
J
1
3
Press PROGRAM
h
repeatedly to switch to the
following display.
4
Press STRAIGHT to change the settings to “ON.”
5
Switch this unit to standby mode, and then switch it
on again.
The bi-amp connection becomes effective and the unit is powered on.
To deactive a bi-amp connection, follow the same procedure and
select “OFF” in step 4.
VOLUME
MIN
MAX
CROSSOVER/
HIGH CUT
MIN
MAX
Subwoofer examples
NOTES
•
Before making bi-amplification connections, remove any
brackets or cables that connect a woofer with a tweeter. Refer to
the instruction manuals of speakers for details. When not making
bi-amplification connections, make sure that the brackets or
cables are connected before connecting the speaker cables.
•
If connecting a bi-amp, then surround back speakers cannot be
used.
FRONT
SURROUND BACK/
BI-AMP
PHONES
SILENT CINEMA
TONE CONTROL
STRAIGHT
TV
BD
DVD
CD
RADIO
INPUT
PROGRAM
SCENE
INFO
MEMORY
PRESET
FM
AM
YPAO MIC
STRAIGHT
PROGRAM
l
/
h
A
BI-AMP-OFF
J
J
1 :
Refer to the “Extended functionality that can be configured as needed
(Advanced Setup menu)” (
) for details on the Advanced Setup menu.