CONFIGURATIONS
➤
Configuring various functions (Setup menu)
En
77
■
Volume
Configures the volume settings.
❑
Dynamic Range
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and
DTS signals) playback.
Settings
❑
Max Volume
Sets the maximum volume to prevent excessive loudness.
Setting range
-30.0 dB to +15.0 dB (5.0 dB increments), +16.5 dB
Default
+16.5 dB
❑
Initial Volume
Sets the initial volume when the receiver is turned on.
Settings
❑
ZoneB Volume
(RX-V575 only)
Selects whether to adjust the volume for Zone B in conjunction with the volume for Zone A.
Settings
• If “ZoneB Volume” is set to “Async.”, the volume for Zone B is temporarily set to -40 dB. As necessary,
adjust the volume using the remote control (p.62).
ECO
Configures the power supply settings.
■
Auto Power Standby
Sets the amount of time for the auto-standby function. If you do not operate the unit for
the specified time, the unit will automatically go into standby mode.
Settings
Default
U.K. and Europe models: 8 hours
Other models: Off
• Just before the unit enters standby mode, “AutoPowerStdby” appears and then countdown starts in the
front display.
Maximum (default)
Produces audio without adjusting the dynamic range.
Standard
Optimizes the dynamic range for regular home use.
Min/Auto
Sets the dynamic range for clear sound even at night or at low
volumes.
When playing back Dolby TrueHD signals, the dynamic range is
automatically adjusted based on the input signal information.
Off (default)
Sets the level to the volume level of the unit when it last entered
standby mode.
Mute
Sets the unit to mute the audio output.
-80.0 dB to +16.5 dB
(0.5 dB increments)
Sets the level to the specified volume level.
Sync. (default)
Adjusts the volume for Zone B in conjunction with the volume for
Zone A.
Async.
Does not adjust the volume for Zone B in conjunction with the volume
for Zone A. Adjust the volume for Zone B separately (p.62).
Off
Does not set the unit to standby mode automatically.
2 hours, 4 hours,
8 hours, 12 hours
Sets the unit to standby mode when you have not operated the unit for
the specified time. For example, when “2 hours” is selected, the unit
will switch to standby mode if you do not operate it for 2 hours.
S e t u p
S p e a k e r
H D M I
S o u n d
E C O
F u n c t i o n
N e t w o r k
L a n g u a g e
A u t o P o w e r S t a n d b y
E C O M o d e
Downloaded from www.vandenborre.be
