Yamaha Grizzly 700 2011, Manual

Page: 59 / 172

6-1
6
EBU19881
OPERATION
EBU19901
Read the Owner’s Manual carefully before riding
the ATV. If there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
EWB00631
Read the Owner’s Manual carefully to become
familiar with all controls in order to help pre-
vent any loss of control, which could cause an
accident or injury.
EBU30500
Starting the engine
NOTICE
ECB00150
See the “Engine break-in” section on page 6-4
prior to operating the engine for the first time.
1. Turn the key to “ ” (on) and the engine stop
switch to “ ”.
The following warning lights should come on
for a few seconds, then go off.
●
Coolant temperature warning light
●
Engine trouble warning light
The EPS warning light should come on, then
go off when the engine is started.
NOTICE
ECB00824
If a warning light does not go off, see page 4-2
for the corresponding warning light circuit
check. To avoid possible damage, do not oper-
ate the ATV if a warning light stays on.
2. Apply the brake pedal, and then shift the drive
select lever into the neutral or park position.
The corresponding indicator light should
come on. If the indicator light does not come
on, have a Yamaha dealer check the electrical
circuit.
TIP
This model is equipped with an ignition circuit cut-
off system. The engine can be started under the
following conditions:
● The drive select lever is in the neutral or park po-
sition.
U1HP60E0.book Page 1 Monday, April 11, 2011 7:56 PM