8-33
8
case. Never operate the engine with the air
filter element removed. This will allow un-
filtered air to enter the engine, causing
rapid engine wear and possible engine
damage. Additionally, operation without
the air filter element will affect carburetor
jetting with subsequent poor performance
and possible engine overheating.
[ECB00462]
12. Install the seat.
TIP
The air filter element should be cleaned every 20–
40 hours. It should be cleaned and lubricated
more often if the ATV is operated in extremely
dusty areas. Each time the air filter element main-
tenance is performed, check the air inlet of the air
filter case for obstructions. Check the air filter
case rubber joint to the carburetor fittings and the
rubber joint manifold fittings for an air-tight seal.
Tighten all fittings securely to avoid the possibility
of unfiltered air entering the engine.
EBU27083
Cleaning the spark arrester
Be sure the exhaust pipe and muffler are cool be-
fore cleaning the spark arrester.
1. Remove the tailpipe bolts.
2. Remove the tailpipe by pulling it out of the
muffler.
3. Tap the tailpipe lightly, and then use a wire
brush to remove any carbon deposits from
the spark arrester portion of the tailpipe and
inside of the tailpipe housing.
1. Tailpipe bolt
2. Tailpipe
U2LC61E0.book Page 33 Wednesday, February 26, 2014 3:56 PM
Summary of Contents for GRIZZLY 450 YFM450DF
Page 19: ...1 8 1 For Oceania 6 1 2 3 4 5 7 8 9 U2LC61E0 book Page 8 Wednesday February 26 2014 3 56 PM ...
Page 21: ...1 10 1 16 UNDER 1P0 F816L 00 7 6 U2LC61E0 book Page 10 Wednesday February 26 2014 3 56 PM ...
Page 70: ...7 1 7 EBU21142 RIDING YOUR ATV U2LC61E0 book Page 1 Wednesday February 26 2014 3 56 PM ...
Page 167: ...11 2 11 1 Model label U2LC61E0 book Page 2 Wednesday February 26 2014 3 56 PM ...