PERIODIC MAINTENANCE AND ADJUSTMENT
7-14
7
5. If the engine oil is at or below the
minimum level mark, remove the
oil filler cap, and then add sufficient
oil of the recommended type to
raise it to the correct level.
6. Insert and tighten the engine oil
dipstick, and then install and tight-
en the oil filler cap.
To change the engine oil (with or
without oil filter cartridge replace-
ment)
1. Remove cowling B. (See page
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Place an oil pan under the engine
to collect the used oil.
4. Remove the engine oil filler cap,
the engine oil drain bolt and its
gasket to drain the oil from the
crankcase.
TIP
Skip steps 5–7 if the oil filter cartridge is
not being replaced.
5. Remove the oil filter cartridge with
an oil filter wrench.
1. Engine oil dipstick
2. Maximum level mark
3. Minimum level mark
1. Engine oil filler cap
1
2
3
1
1. Engine oil drain bolt
2. Gasket
1. Oil filter cartridge
2. Oil filter wrench
1
2
1
2
U36P12E0.book Page 14 Monday, October 25, 2010 5:21 PM
Summary of Contents for FZ6R
Page 11: ...LOCATION OF IMPORTANT LABELS 1 4 1 1 U36P12E0 book Page 4 Monday October 25 2010 5 21 PM ...
Page 114: ...A5 yoko_Blank fm Page 1 Tuesday April 8 2003 11 43 AM ...
Page 115: ...A5 yoko_Blank fm Page 1 Tuesday April 8 2003 11 43 AM ...
Page 116: ...PRINTED IN JAPAN 2010 11 0 6 1 CR E PRINTED ON RECYCLED PAPER YAMAHA MOTOR CO LTD DIC183 ...