Control functions
27
If a problem is detected in any of those cir-
cuits, the warning light and the engine trouble
warning indicator flash, and an error code
flashes slowly in the meter display. Note the
error code, and then have a Yamaha dealer
inspect the snowmobile as soon as possible.
NOTICE:
Do not continue to operate the
engine longer than necessary if there is an
error code to avoid possible engine dam-
age.
[ECS00820]
ESU10531
Engine stop switch “ ”
The engine stop switch is used to stop the en-
gine in an emergency. Simply push the stop
switch to stop the engine. To start the engine,
pull the stop switch and proceed with starting
the engine. (See page 50 for engine starting
procedures.)
During the first few rides, practice using the
stop switch so that you can react quickly in an
emergency.
ESU10661
Headlight beam switch
“LIGHTS”
Push the headlight beam switch to change the
headlight to high beam “HI” or to low beam
“LO”.
ESU12654
Grip/thumb warmer adjusting
switch
The grip warmer adjusting switch and the
thumb warmer adjusting switch control the
electrically heated handlebar grips and throt-
tle lever respectively.
1. Warning light “
”
2. Engine trouble warning indicator “
”
3. Error code display
1. Engine stop switch “
”
3
2
1. Headlight beam switch “LIGHTS”
2. High beam “HI”
3. Low beam “LO”
1. Grip warmer adjusting switch
1
U8HKS4E0.book Page 27 Tuesday, May 8, 2012 9:27 AM
