Yamaha FS1R, Owner'S Manual

Page: 48 / 88

SendIns
→
Rev
❑
Insertion-to-Reverb Send Level
❑
Settings: 0 … 127
Sets the amount of signal sent from the output of the insertion effect stage back to the input of the reverb effect
stage (see diagram on page 13). The higher the value, the more insertion signal is sent to the reverb stage.
SendIns
→
Var
❑
Insertion-to-Variation Send Level
❑
Settings: 0 … 127
Sets the amount of signal sent from the output of the insertion effect stage back to the input of the variation effect
stage (see diagram on page 13). The higher the value, the more insertion signal is sent to the variation stage.
InsDryLevel
❑
Insertion Dry Level
❑
Settings: 0 … 127
Sets the level of the “dry” (direct) sound in relation to the insertion effect sound. Higher values produce a “drier”
signal.
EQ
This is a versatile 3-band equalizer with variable frequency and Q (bandwidth) for all bands. The low and high
bands can be switched for peaking or shelving operation.
Low Freq
❑
Low-band Frequency
❑
Settings: 32 … 2.0k
Sets the rolloff or center frequency of the low EQ band.
Low Gain
❑
Low-band Gain
❑
Settings: -12 … 0 … +12
Sets the amount of boost (“+” settings) or cut (“-” settings) applied to the low EQ band.
Low Q
❑
Low-band Q
❑
Settings: 0.1 … 12.0
Sets the Q or bandwidth of the low EQ band when the “peak” mode is selected via the “Low Shape” parameter,
below. Higher values produce a narrower bandwidth. The Q parameter cannot be adjusted when the “shelv” mode
is selected.
Low Shape
❑
Low-band Shape
❑
Settings: peak, shelv
Determines whether the low EQ band has a peaking or shelving response. The “Low Q” parameter, above, only
becomes available when the “peak” mode is selected.
48
2/FS1R/EDIT/E.qx 10/19/98 7:23 PM Page 48